Sun Microsystems SPARCstorage Library Service Manual page 126

6
6.1 Tape Drive in the Drive Carrier or Drive Blank
!
6.1.1 Removing the Drive Carrier or Drive Blank
6-2
In this section, drive carrier refers to a tape drive installed in a drive carrier.
Caution – If you operate the tape library with only one tape drive, you must
have a drive blank installed in the outside drive carrier slot (the left slot in the
table top and rack-mounted units or the bottom slot in the tower unit).
Failure to install a drive blank will interrupt the SCSI bus, and failure to install
the drive blank in the outer slot will disrupt air flow within the library.
Before you begin any procedure in this section, make sure you:
Obtain a long medium size flatblade screwdriver.
1. Make sure the power is on.
2. Make sure data cartridges are not in the tape drives. The top/right and
bottom/left LEDs on the tape drives must be off.
If the top/right and bottom/left LEDs are steadily flashing:
a. Open the front door.
SPARCstorage Library Service Manual—June 1995