To View Or Change Scsi Ids; Figure 2-3 Location Of The Tape Drives - Sun Microsystems SPARCstorage Library Service Manual

Hide thumbs Also See for SPARCstorage Library:
Table of Contents

Advertisement

Second tape
First tape
drive
drive
Rack-mounted unit
Figure 2-3
Location of the Tape Drives
Under the Solaris 2.x software environment, you can set the SCSI IDs of the
tape drive to any available SCSI ID not used elsewhere on the SCSI bus,
from 0 - 6. SCSI IDs 4 and 5 are most commonly used for tape drives. SCSI ID
7 is reserved for the host or the SCSI host adapter card.

To view or change SCSI IDs

1. Disable security (the display panel must read Set Security On when
security is disabled).
If the display panel reads Set Security Off, security is turned on. See "To
enable or disable security" on page 2-22.
2. Select the Configuration Menu by pressing
3. Select Set SCSI IDs by pressing
4. Set the SCSI IDs for CTS 1 (tape drive 1), CTS 2 (tape drive 2) and the
tape library (LIB).
a. Press
or
to select the devices.
b. Press
or
to increase or decrease the SCSI ID value.
c. Press Enter to make the selection active.
Troubleshooting
First tape
drive
Second tape
drive
Tower unit
or
, then Enter.
or
, then Enter.
2
2-17

Advertisement

Table of Contents
loading

Table of Contents