Bar Code Scanner; Preparing To Remove And Install - Sun Microsystems SPARCstorage Library Service Manual

6

6.5 Bar Code Scanner

6.5.1 Preparing to Remove and Install the Bar Code Scanner
6-26
1. Turn off the power but leave the power cord connected to the wall outlet.
2. Attach a wrist strap to your wrist and to a metal portion at the rear of the
chassis.
3. Remove the top cover (table top and rack-mounted units) or the right
panel (tower unit).
See Section 5.1.3, "Removing the Top Cover," on page 5-8 and Section 5.2.2,
"Removing the Right Plastic and Metal Panels," on page 5-14.
ADD REFERENCE TO TABLE TOP SECTION
4. Lay the tape library on a work bench on its side (horizontally) with the
opening at the top.
See Figure 6-19 on page 6-27.
5. Open the door.
6. Obtain the following tools:
• T-10 TORX bit
• T-15 TORX bit
SPARCstorage Library Service Manual—June 1995