Scan Test - Sun Microsystems StorEdge L400 Installation And User Manual

Note – If you insert a tape cartridge into a drive, the drive does not automatically
eject the cartridge. The system displays an error message if there is no cartridge in
the source element slot or if the destination element slot is full.
1. Select the Maintenance Menu by pressing
2. Select the Diagnostics Menu by pressing
3. Select Move Cartridge by pressing
The system displays the following screen:
Set Source
↑ Increase
↓ Decrease
4. Select the element index of the cartridge slot from which you want the CHM to
pick the cartridge by pressing
The system displays the following screen:
Set Destination
↑ Increase
↓ Decrease
5. Select the element index of the cartridge slot from which you want the CHM to
place the cartridge by pressing
The CHM moves the cartridge from the source to the destination.
7.4.3.5

Scan Test

The Scan test scans all the elements. The information is stored in the cartridge
inventory. Scan errors and the contents of labels are displayed on the Label
Information screen.
1. Select the Maintenance Menu by pressing
2. Select the Diagnostics Menu by pressing
3. Select Scan by pressing
The bar code scanner scans all the elements.
To abort this diagnostic, press Escape and Enter.
7-18 Sun StorEdge L400 Installation and User's Guide • April 1998
↓
or
↓
↓ ↑
or , then Enter.
0
↑ ↓,
or then Enter.
↑ ↓
or , then Enter.
↓
↓
↓ ↑
or , then Enter.
↑
, then Enter.
↑
or , then Enter.
↑
or , then Enter.
↑
or , then Enter.