RMG USM GT400 Operating Manual page 85

1 Clean the device and protect all blank parts against corrosion with an acid-
free corrosion protection agent, e.g., ESSO RUST BAN 397, Mobil Oil Tecrex
39.
Chapter 11.7, "Cleaning the device" on page 167
2 Place the corrosion protection mat (1) inside the device.
▪ Provide the connection box (ATEX / IECEx) with blind plugs
1 Insert the blind plugs (3) into the connection.
2 Tighten the screw connection (2) with a suitable wrench (1).
The following sealing bolts supplied must be used in countries where CSA
guidelines apply. If only transport is taking place, you can use 1/2" or 1"
screws with appropriate length as an alternative.
▪ Applying the protective sticker / blind plugs to the flanges
The flanges must be sealed with a protective sticker or blind plug made of
plastic.
1 Wrench
2 Screwed cable gland
3 Blind plug
Fig. 6.11: Mount the blind plugs
6 Transport and storage
Manual USM GT400 · EN10 · May 2021
77