Table of Contents
Advertisement
6 Transport and storage
Removing the protective sticker
72
Remove the blind plugs
▪ Remove the corrosion protection mat
The inside of the device is protected using a corrosion protection mat. The corro-
sion protection mat must be removed before installation.
1
Remove the corrosion protection mat (1) from the device.
Manual USM GT400 · EN10 · May 2021
1
Corrosion protection mat
Fig. 6.6: Position of the corrosion protection mat
1
Release the protective sticker from
the sealing surface of the flange.
2
Remove any residual adhesives or
other impurities from the sealing
surfaces of the flange using a gentle
cleaning agent.
1
Pull the blind plugs out of the
openings.
Advertisement
Table of Contents
