Table of Contents
Advertisement
3.2 Ultrasonic electronics
Fig. 3.2: Ultrasonic electronics and display
Device data (readings and parameters) can be set and evaluated via the display
and the operating elements.
Moreover, the device data (readings and parameters) can also be shown, evalu-
ated and set using the RMGViewUSM software.
Service and calibration switch (1)
The service switch (right switch) is only for RMG service. The service switch is,
e.g., used to install new firmware.
The calibration switch (left switch) protects the parameters against unauthorized
changes. The device can be configured by opening the calibration switch.
Control panel (2)
The control field comprises buttons that are triggered by pressing a button or mag-
netically. Parameters, readings, warning, alarm and status messages are called up
using the button.
Display (3)
The display shows the readings, warning, alarm and status messages as well as
the parameters.
Magnet for operation (4)
The magnet is used to operate the control panel of the ultrasonic electronics when
the housing is closed. If the magnet is placed above the symbol on the viewing
window, this function is activated.
1 Service- and calibration switch
2 Control panel
3 Display
4 Magnet for operation
5 Cover with viewing window
6 Pressure tight housing
3 Device overview
Manual USM GT400 · EN10 · May 2021
27
Advertisement
Table of Contents
