Calling Up The Value Of A Parameter - RMG USM GT400 Operating Manual

10 Operation
10.2.1

Calling up the value of a parameter

140
The coordinates (column and line) of the parameter are selected. The value of the
parameter is shown on the display.
Manual USM GT400 · EN10 · May 2021
▪ Select the column in the coordinate system
Select the column of the coordinate on the control panel of the
ultrasonic electronics using the button.
The button has been allocated with the following functions for
navigating:
• Press the button briefly: one column to the right, e.g., from
A to B.
• Press the button longer: depending on the duration of
pressing the button:
- one column to the left, e.g., from B to A.
- continuously column by column to the left, e.g., from
U to F.
1 Press the button to select the desired column.
▪ Select the line in the coordinate system
Select the line of the coordinate on the control panel of the ul-
trasonic electronics using the button.
The buttons have been allocated with the following functions
for navigating:
• Press the button briefly: one column down, e.g., from
E-01 to E-02.
• Press the button longer: continuously line by line down-
wards.
• Press the button briefly: one column up, e.g., from
E-02 to E-01.
• Press the button longer: continuously line by line upwards.
1 Press the buttons to select the desired line.