Packing The Device For Transportation - RMG USM GT400 Operating Manual

6.2 Packing the device for transportation

The device must be packed to customer-specifics according to the transport re-
quirements. In this chapter you will receive information as to how the device is as
standard packed.
For packaging, use the original packaging material and sealing set that was
supplied with the device.
If you no longer have the original packaging material and sealing set, you can or-
der the packaging material and sealing set required from RMG.
RMG service would be pleased to consult you as to how the device should be
packed.
You need the following for standard packaging:
• Euro pallet with timber wedges (with the original packaging, the timber
wedges are already pre-mounted on the Euro pallet).
• Two tensioning straps
• Transport locks
• Sealing set (blind plugs)
• Acid-free corrosion protection agent, e.g., ESSO RUST BAN 397,
Mobil Oil Tecrex 39
▪ Ensure for a safe position of the device
Caution
Risk of injury from missing retaining bolts
If the device is put down without the retaining bolts, it can tip over or roll away.
Severe injuries may occur.
•
Before starting work, make sure that the retaining bolts are screwed in.
6 Transport and storage
Manual USM GT400 · EN10 · May 2021
73