Waters TRIZAIC UPLC System Manual page 46

Cleaning the fluid-line connectors and electronic connectors:
To remove buildup from fluid-line connectors:
Gently swab the fluid-line connectors and outer edges of the docking port with
a lint-free tissue saturated with isopropanol or methanol.
To remove buildup from electronic connectors:
1. Open the source door.
2. From the back, gently direct a stream of air from a clean source across
the electronic connectors.
Note:
into the source.
3. Close the source door.
To clean the outside surfaces of the TRIZAIC UPLC source:
1. Use a lint-free tissue, dampened with water.
2. Clean the other system components according to the supplied
documentation.
SYNAPT-series or Xevo-series mass spectrometer documentation.
See also:
3-8 Maintenance Procedures
To prevent contamining the inside of the source, do not direct air
Electronic connectors
Fluid-line connectors