Procedure To Execute The Factory Recovery (Hdd Revision: Nm320 Or Below) - Keysight E5052B Service Manual

System Recovery
System Recovery
Procedure to execute the factory recovery (HDD Revision: NM320 or
below)
This section describes how to return the contents of the C drive to the factory state.
NOTE
You need a keyboard for this operation.
Step 1. Shut down the E5052B.
Step 2. Disconnect all of the USB device from the USB ports.
Step 3. Connect the keyboard to the E5052B.
Step 4. Press the standby switch of the E5052B to turn it on.
Step 5. When the screen as shown in the figure below appears, press
Starting Acronis Loader...
Press F11 for Acronis Startup Recovery Manager...
e5071cse1055
CAUTION
Press F11 only once. If you press F11 twice or more and a screen which is not mentioned in
this manual appears, reboot the instrument and restart the process from the first.
NOTE
After several seconds, the next screen appears automatically even if you do not press any
key, so do not miss it.
NOTE After
remove unnecessary USB devices. Then, replace the keyboard with a PS/2 keyboard to
execute the process again.
208
Step 5, if the E5052B freezes with the cursor does not blink, turn the power off and
of the keyboard.
F11
Appendix B