Replacement Procedure
A22 Power Distribution Board Replacement
A22 Power Distribution Board Replacement
Tools Required
•
TORX screwdriver, T10,T15 and T20
Removal Procedure
Refer to
Figure 6-15
Step 1. Remove the outer cover as described in
Step 2. Remove the power supply as described in
page
146.
Step 3. Disconnect the cables from the power distribution board.
Step 4. Remove the two TORX T10 screws (item 1) fastening the plate.
Step 5. Remove the plate (item 2) from the power distribution board.
Step 6. Remove the five TORX T10 screws (item 3) fastening the power distribution board.
Step 7. Slide the power distribution board (item 4) from the analog motherboard.
164
for this procedure.
"Outer Cover Removal" on page
"Power Supply Assembly Replacement" on
136.
Chapter 6