Removable Hard Disk Drive Replacement; Tools Required; Save Backup Files To The Pc; Removal Procedure - Keysight E5052B Service Manual

Replacement Procedure

Removable Hard Disk Drive Replacement

Removable Hard Disk Drive Replacement

Tools Required

• TORX screwdriver, T10
• Torque screwdriver, TORX T10

Save Backup Files to the PC

When the removable hard disk drive is readable, you have to perform the following steps.
For details of the adjustment progra, refer to
Step 1. Run the adjustment program.
Step 2. Perform the adjustment using "Backup" in

Removal procedure

Refer to Figure 6-4
Step 1. Insert the key (P/N 1390-1375) in the lock and turn clockwise (item 1).
Step 2. Loosen a screw (item 2).
Step 3. Press the button under the screw (item 3) and remove the hard disk (item 4).
Step 4. Remove the four TORX T10 screws (item 5), and remove the removable hard disk drive's
lid (item 6).
Step 5. Remove the four TORX T10 screws (item 7) fastening the HDD bracket and remove it.
Step 6. Remove the hard disk drive (item 8) from the connector board.
142
Chapter 6 on page
Spot Adjustment
for this procedure.
133.
of the program.
Chapter 6