Receiver If Gain/Flatness Adjustment; Receiver Rf Flatness Dir Adjustment - Keysight E5052B Service Manual

Receiver IF Gain/Flatness Adjustment

The purpose of this procedure is to adjust the IF gain / flatness of the A6 phase detector
board.
Required equipment for the receiver IF gain/flatness adjustment
Description
Signal Generator
50 ohm Termination
Power Sensor
Power Meter
Power Splitter
N(m)-N(m) Cable
N(m)-N(m) Adapter

Receiver RF Flatness Dir Adjustment

The purpose of this procedure is to adjust the RF flatness of the A6 phase detector board.
Required equipment for the receiver RF flatness adjustment
Description
Signal Generator
50 ohm Termination
Power Sensor
Power Meter
Power Splitter
N(m)-N(m) Cable
N(m)-N(m) Adapter
Chapter 3
Required Adjustment after Replacing Assembly
Recommended Model
Keysight E8257D with Opt. UNX, UNT, 1EA
without Opt. UNW, 1EH
Keysight 909C opt.012
Keysight E9304A Opt. H18 or Keysight E9304A
Opt. H19
Keysight E4419A/B
Keysight 11667A
Keysight N6314A (p/n 8120-8862)
Keysight p/n 1250-1475
Recommended Model
Keysight E8257D with Opt. UNX, UNT, 1EA
without Opt. UNW, 1EH
Keysight 909C Opt. 012
Keysight E9304A with Opt. H18 or Keysight
E9304A Opt. H19
Keysight E4419A/B
Keysight 11667A
Keysight N6314A (p/n 8120-8862)
Keysight p/n 1250-1475
Adjustment
49