A26 Digital Bridge Board Replacement; Tools Required; Removal Procedure - Keysight E5052B Service Manual

Replacement Procedure

A26 Digital Bridge Board Replacement

A26 Digital Bridge Board Replacement

Tools Required

• TORX screwdriver, T10, T15, and T20

Removal Procedure

Refer to Figure 6-7
Step 1. Remove the outer cover as described in
Step 2. Remove the three TORX T10 screws (item 1) fastening the angle.
Step 3. Disconnect the flat cable (item 2) from the PCI DSP card.
Step 4. Disconnect the flat cables (item 3) from the digital bridge board.
Step 5. Remove the two TORX T10 screws (item 4) fastening the board to the rear panel.
Step 6. Lift the digital bridge borad (item 5).
Step 7. Disconnect the cables (item 6) from the digital bridge board.
Step 8. Remove the two TORX T10 screws (item 7) fastening the angle.
148
for this procedure.
"Outer Cover Removal" on page 136.
Chapter 6