Replacement Procedure - Keysight E5052B Service Manual

Figure 6-4 Removable Hard Disk Drive Removal
2
3
7
e5052bse1106

Replacement Procedure

Step 1. Replace the removable hard disk drive by inverse procedure of removal.
NOTE Fasten the TORX T10 screws (item 5) using a torque screwdriver (set to 1.02 N-m / 9.0
lb-in).
Fasten the TORX T10 screws (item 6) using a torque screwdriver (set to 0.50 N-m / 4.4
lb-in).
Step 2. Insert the hard disk into the slot.
Step 3. Turn the key to the left until it is locked, then remove the key.
Step 4. When the "Backup" in Spot Adjustment has been done, restore backup files onto the new
removable hard disk drive as described in
Hard Disk Drive" on page
Step 5. If the "Backup" in Spot Adjustment has not been done, restore backup files onto the new
removable hard disk drive as described in
Drive" on page
Chapter 6
4 1
144.
144.
Replacement Procedure
Removable Hard Disk Drive Replacement
5
6
8
"Restore Backup Files onto the New Removable
"Adjustment for the New Removable Hard Disk
5
143