System Recovery; Types Of System Recoveries - Keysight E5052B Service Manual

System Recovery

System Recovery
System Recovery
By executing system recovery, you can return the system of the E5052B (the Windows
operating system and the firmware) to the factory state (at the time of purchase
NOTE System recovery is a function of Windows and not a function of the E5052B Firmware.
The system recovery procedure is different in accordance with the HDD revision. The
HDD revision can be confirmed using the following procedure:
Step 1. In E5052B, from Windows Start Menu, click on My Computer.
Step 2. The volume label for C: drive is displayed in Hard Disc Drive area.
CAUTION
Strictly follow the steps described below. If you do any operation other than the following
steps, the system may not be recovered.

Types of system recoveries

The following 2 types of system recoveries are available.
o Factory recovery
o User recovery (available only when the HDD revision is NM320 or below)
204
Returns the contents of the C drive to the factory state.
Returns the contents of the C and F drives to a user-specified state. To use this function,
you must prepare for recovery in advance. For information on the preparation, see
"Procedure to create the user backup image (only available when HDD Revision is
NM320 or below)" on page 210
execute the user recovery function (only available when HDD Revision is NM320 or
below)" on page 217.
*1.If the hard disk failed and has been replaced after purchase, the state when the replacement
was performed is recovered.
for information on the execution, see
*1
).
"Procedure to
Appendix B