Replacement Procedure
A52 Inverter Assembly Replacement
A52 Inverter Assembly Replacement
Tools Required
•
•
•
Removal Procedure
Refer to
Step 1. Remove the outer cover as described in
Step 2. Remove the front panel as described in
Step 3. Remove the front panel cover as described in
Step 4. Disconnect the three cables (item 1) connected front panel keyboard.
NOTE
Be careful to remove the cables (item 1), and not apply any scratches on the cables.
Step 5. Remove the two TORX T15 screws (item 2) fastening the inverter assembly.
Step 6. Disconnect the two cables (item 3) connected the inverter assembly.
182
TORX screwdriver, T10, T15, and T20
Open-end torque wrench, 5/16 inch (set to 1.02 N-m / 9.0 lb-in) (for reconnecting SMA
connector)
Flat edge screwdriver
Figure 6-25
for this procedure.
"Outer Cover Removal" on page
"Front Panel Removal" on page
"Front Panel Cover Removal" on page
136.
138.
180.
Chapter 6