Tools Required; Initial Instrument Functionality Check; Instrument Software Revision Check - Keysight X Series Installation Notes

Signal analyzer

Hide thumbs Also See for X Series:

Table of Contents

Option ST1 and ST2 – IQ Streaming

Tools Required

—

Torx Driver T-10

—

Torx Driver T-20

—

Multi-Bit Torque Driver

—

5/8" Nut Driver

—

5/16" Wrench

Power on the instrument and allow it to complete its boot up process. Verify that there are no

instrument messages that would indicate that there is an issue with either the instrument hardware

or software. If there are any issues, investigate and fix the problem before continuing with this

upgrade.

While the instrument is still powered on check to see what version of the instrument software is

installed. To do so press System, Show System and look on the System Information screen for the

Instrument S/W Revision. Record the software revision below.

Instrument S/W Revision Installed: __________

Installation Note N9032-90010

Table of Contents

N9032b