A32 Usb (Usbtmc) Interface Card Replacement; Tools Required; Removal Procedure - Keysight E5052B Service Manual

Replacement Procedure

A32 USB (USBTMC) Interface Card Replacement

A32 USB (USBTMC) Interface Card Replacement

Tools Required

• TORX screwdriver, T10, T15, and T20

Removal Procedure

Refer to Figure 6-10
Step 1. Remove the outer cover as described in
Step 2. Remove the three TORX T10 screws (item 1) fastening the angle.
Step 3. Remove two TORX T10 screws (item 2) fastening the PCI DSP card/GPIB card assembly
to the rear panel.
Step 4. Lift the USB (USBTMC) interface card (item 3) from the digital motherboard carefully.
Step 5. Remove the two TORX T10 screws (item 4) fastening the angle.
154
for this procedure.
"Outer Cover Removal" on page 136.
Chapter 6