A3 Adc/Dsp Board Replacement; Tools Required; Removal Procedure - Keysight E5052B Service Manual

Replacement Procedure

A3 ADC/DSP Board Replacement

A3 ADC/DSP Board Replacement

Tools Required

• TORX screwdriver, T10, T15, and T20
• Flat edge screwdriver
• Open-end torque wrench, 5/16 inch (set to 1.02 N-m / 9.0 lb-in) (for reconnecting SMA
connector)

Removal Procedure

Refer to Figure 6-19
Step 1. Remove the outer cover as described in
Step 2. Remove the front panel as described in
Step 3. Release the clamped cables from the clamp (item 1).
Step 4. Disconnect the RF cables (item 2) from the ADC/DSP board.
Step 5. Remove the two TORX T10 screws (item 3).
Step 6. Slide out the ADC/DSP board (item 4).
172
for this procedure.
"Outer Cover Removal" on page 136
"Front Panel Removal" on page 138.
Chapter 6