Mitsubishi Electric MELSERVO-J2S Series Transition Handbook page 313

Part 7: Common Reference Material
MR-J2S-_CP_
No. Name
87 For manufacturer setting
88 For manufacturer setting
- -
- -
MR-J4-_A_-RJ
Type Target No. Type
_ _ XX PD23 Hex
Hex
XX _ _ PD26 Hex
_ _ XX PD27 Hex
Hex
XX _ _ PD28 Hex
- - PA21 Hex
Hex
Hex
- - PA01
Hex
Hex
Hex: hexadecimal parameter; Dec: decimal parameter
7 - 74
Conversion rule
Target
The setting value will be converted as shown in
Table 2 (as output).
However, a setting value other than those in
Table 2 will be converted to _ _04.
When conversion of I/O signal assignment is
enabled, this parameter will be converted
_ _ XX
according to the control signal connection of the
renewal tool.
When conversion of I/O signal assignment is not
enabled, the initial value will be used.
This parameter can be used with MR
Configurator2 of software version 1.53F or later.
The setting value will be converted as shown in
Table 2 (as output).
However, a setting value other than those in
Table 2 will be converted to _ _07.
When conversion of I/O signal assignment is
enabled, this parameter will be converted
_ _ XX
according to the control signal connection of the
renewal tool.
When conversion of I/O signal assignment is not
enabled, the initial value will be used.
This parameter can be used with MR
Configurator2 of software version 1.53F or later.
The setting value will be converted as shown in
Table 2 (as output).
However, a setting value other than those in
Table 2 will be converted to _ _03.
When conversion of I/O signal assignment is
enabled, this parameter will be converted
_ _ XX
according to the control signal connection of the
renewal tool.
When conversion of I/O signal assignment is not
enabled, the initial value will be used.
This parameter can be used with MR
Configurator2 of software version 1.53F or later.
The setting value will be converted as shown in
Table 2 (as output).
However, a setting value other than those in
Table 2 will be converted to _ _02.
When conversion of I/O signal assignment is
enabled, this parameter will be converted
_ _ XX
according to the control signal connection of the
renewal tool.
When conversion of I/O signal assignment is not
enabled, the initial value will be used.
This parameter can be used with MR
Configurator2 of software version 1.53F or later.
3 _ _ _ will be set.
X _ _ _
To use the HC/HA series servo motors without
being replaced, refer to (5) in Section 2.3.5.
_ _ _ 6 will be set.
_ _ _ X
(Point table method)
_ _ X _ _ _ 0 _ will be set. (Standard control mode)
_ X _ _ _ 0 _ _ will be set.
X _ _ _ 1 _ _ _ will be set.