Mitsubishi Electric MELSERVO-J2S Series Transition Handbook page 146

Part 4: Review on Replacement of MR-J2S-_CP_/CL_ with MR-J4-_A_-RJ
MR-J2S-_CP_ or MR-J2S-_CL_
No. Name and function
63
Low-pass filter/adaptive vibration suppression control
Select the low-pass filter/adaptive vibration suppression
control.
0
Low-pass filter selection
0: Available (Automatic adjustment)
1: Disabled
When available is selected, the filter in the zone
expressed by the following formula is automatically
set.
For 1 kW or less
VG2 setting value × 10
2π × (1 + GD2 setting value ×
For 2 kW or more
VG2 setting value × 5
2π × (1 + GD2 setting value ×
Adaptive vibration suppression control selection
Selecting "Enabled" or "Retained" for the adaptive
vibration suppression control will disable the machine
resonance suppression filter 1 (Parameter No.61).
0: Disabled
1: Available
Usually, machine resonance frequency is detected,
and a filter corresponding to the resonance is
generated to control machine vibration.
2: Maintenance
Stops detection of machine resonance while
keeping the characteristics of the filter generated
until that moment.
Adaptive vibration suppression control level selection
Used to set the machine resonance detection
sensitivity.
0: Normal
1: High sensitive
[Hz]
0.1)
[Hz]
0.1)
Initial value
No.
CP CL
0000h 0000h PB23 Low-pass filter selection
0 0
Set "0000 (automatic setting)".
PB18 Low-pass filter setting
One of the following statuses is applied,
depending on how [Pr. PB23] is set.
(Initial value)
Nothing needs to be set due to automatic
setting.
PB01 Adaptive tuning mode (adaptive filter II)
Refer to MR-J2S-_CP_ [Pr. 61].
4 - 37
MR-J4-_A_-RJ
Name and function
0
Low-pass filter
0: Automatic setting
1: Manual setting
2: Disabled
PB23 PB18
_ _ 0 _ Automatic setting
_ _ 1 _ Setting value enabled
_ _ 2 _ Setting value disabled
Initial
value
0000h
3141
0000h