Mitsubishi Electric MELSERVO-J2S Series Transition Handbook page 311

Part 7: Common Reference Material
MR-J2S-_CP_
No. Name
82 For manufacturer setting
83 For manufacturer setting
MR-J4-_A_-RJ
Type Target No. Type
_ _ XX PD14 Hex
Hex
XX _ _ PD04 Hex
_ _ XX PD18 Hex
Hex
XX _ _ PD20 Hex
Hex: hexadecimal parameter; Dec: decimal parameter
7 - 72
Conversion rule
Target
The setting value will be converted as shown in
Table 1 (as input).
However, a setting value other than those in
Table 1 will be converted to 39 _ _.
When conversion of I/O signal assignment is
enabled, this parameter will be converted
XX _ _
according to the control signal connection of the
renewal tool.
When conversion of I/O signal assignment is not
enabled, the initial value will be used.
This parameter can be used with MR
Configurator2 of software version 1.53F or later.
The setting value will be converted as shown in
Table 1 (as input).
However, a setting value other than those in
Table 1 will be converted to 02 _ _.
When conversion of I/O signal assignment is
enabled, this parameter will be converted
XX _ _
according to the control signal connection of the
renewal tool.
When conversion of I/O signal assignment is not
enabled, the initial value will be used.
This parameter can be used with MR
Configurator2 of software version 1.53F or later.
The setting value will be converted as shown in
Table 1 (as input).
However, a setting value other than those in
Table 1 will be converted to 0A _ _.
When conversion of I/O signal assignment is
enabled, this parameter will be converted
XX _ _
according to the control signal connection of the
renewal tool.
When conversion of I/O signal assignment is not
enabled, the initial value will be used.
This parameter can be used with MR
Configurator2 of software version 1.53F or later.
The setting value will be converted as shown in
Table 1 (as input).
However, a setting value other than those in
Table 1 will be converted to 0B _ _.
When conversion of I/O signal assignment is
enabled, this parameter will be converted
XX _ _
according to the control signal connection of the
renewal tool.
When conversion of I/O signal assignment is not
enabled, the initial value will be used.
This parameter can be used with MR
Configurator2 of software version 1.53F or later.