A2 Front Panel Interface Board - Agilent Technologies PSA Series Service Manual

Assembly Replacement Procedures
Front Frame Subassemblies

A2 Front Panel Interface Board

Removal
1. Remove the RPG knob and volume knob by pulling straight off of the
2. Refer to
3. Unplug the Audio Out (3) cable from the interface board.
4. Unplug the display flat flex cable (4) from the front panel interface
5. Using the T-10 driver, remove the 7 screws (1) that secure the front
6. Lift the front panel interface board from the front frame assembly.
Figure 11-61 A2 Front Panel Interface Board Removal
402
control shafts.
Figure 11-61. Unplug both of the 2-wire backlight cables (2)
from the inverter boards.
board. To do this, you must first pull up on both sides of the locking
mechanism of the ribbon cable connector.
panel interface board (5) to the front frame assembly.
Chapter 11