Agilent Technologies PSA Series Service Manual page 427

a. Press
b. Press
It is very important to enter the number accurately. Since it is a
NOTE
hexadecimal, the letter "O" can not be present, only zeros are used in
the license key number.
c. After you have entered the option designator and the license key
Step 4: Loading Firmware for Measurement Options (if needed)
a. Refer to
b. The options will now be available. Press
Step 5: Entering the IP Address and Host Name
a. To enter the IP address, press
b. To enter the Host Name, press
c. To enter the Subnet Mask, press
d. To enter the Default Gateway, press
e. The Flash configuration is now complete.
Chapter 12
, until the
System More
and . This will activate the alpha editor menu. Use
Licensing Option
the alpha editor to enter the upper case option designator. Press
.
Enter
. The license key number is a hexadecimal number
License Key
that will require the entry of both letters and numbers. Use the
alpha editor to enter the letters and the front panel numeric
keyboard to enter the numbers. You will see your entry in the active
function area. When you have completed entering the license key
number, press .
Enter
number, press
Activate License
Chapter 13 , "Firmware Upgrades."
Flash board does not come preloaded with all possible options, you
must load the option FW at this time. It may be necessary to enter
an IP address when down loading the firmware. See step 5.
assure the options have been loaded.
the address and press
press .
Enter
mask, then press
Enter
default gateway, then press
Configuring a Replacement Flash Memory Assembly
softkey is visible. Press
Licensing
.
System
,
System Config I/O
.
Enter
. Type in the host name and
Host Name
Subnet Mask
.
Default Gateway
.
Enter
Post-Repair Procedures
Since the replacement
, to
Show System
, . Type in
IP Address
. Type in the subnet
. Type in the
427