A6 Scsi Board; Removal; Replacement; A6 Scsi Board (Early Instruments) - Agilent Technologies PSA Series Service Manual

Assembly Replacement Procedures

A6 SCSI Board

A6 SCSI Board
Use ESD precautions when performing this replacement procedure.
CAUTION

Removal

1. Refer to
2. The SCSI board can be removed through the rear panel by pulling up
Figure 11-38 SCSI Board Removal

Replacement

1. Replace the SCSI board by inserting it into the opening on the rear
2. Replace the panel onto the frame by replacing the 6 screws using a
366
Figure 11-38. At the rear of the instrument, use a T-10
driver to remove the 6 screws (1) securing the small panel to the
frame.
on the board to disengage it from the CPU board.
frame. Carefully position the board in the CPU board connector and
push down to mate.
T-10 driver. Torque to 9 inch pounds.
Chapter 11