A3 Front Panel Interface Board - Agilent Technologies N5230A Service Manual

PNA Series Microwave Network Analyzers
N5230A

A3 Front Panel Interface Board

This assembly performs the following functions:
• It routes USB signals between the front-panel USB connector and the A15 CPU board.
• The speaker produces the audio output from signals supplied by the A15 CPU board.
• It supplies power to the two front-panel probe power connectors.
• It routes key pad commands from the A1 keypad to the A15 CPU board.
• It routes display signals from the A15 CPU board to the A2 display assembly.
Checking the USB Port
To verify proper operation of the USB port:
• Connect a known good USB device, such as a USB mouse.
• Wait 15 seconds for the analyzer to verify the device connection, and then check the
operation of the USB device.
• If the device performs correctly, the USB port is functioning properly.
• If the device does not perform correctly, the USB port is faulty. Refer to
A3 Front Panel Interface Board" on page
Checking the Speaker
If no audio is heard:
• Verify that the volume is set correctly and the proper sound driver is loaded; do the
following:
— On the
System
— Click the
Sounds and Multimedia
the sound drivers and volume. If the audio is still not heard, suspect a faulty speaker.
Refer to "Removing the A3 Front Panel Interface Board" on page
Checking the Probe Power Connectors
To verify the probe power operation, refer to
Checking the Operation of the Key Pad Commands
To verify the key pad functionality, refer to
page 4-16.
Checking the Display
To verify the display functionality, refer to
Service Guide N5230-90014
menu, point to
Configure,
icon. Follow the normal Windows procedure to check
7-10.
and then click
Control Panel
"Power Supply Check" on page
"A1 Front Panel Keypad and RPG Test" on
"A2 Display Test" on page
Troubleshooting
Front Panel Troubleshooting
"Removing the
.
7-10.
4-7.
4-18.
4-19