Right-Hand Side Controls - Case CX490D Operator's Manual

Right-hand side controls

Right-hand side controls
(1) Starter switch ( 4 positions ): ON (contact), START
(engine ignition), OFF (engine shut-down) and ACC (ac-
cessory current supply).
NOTICE: when the starter key is in ON position, if the
anti-theft protection has been programmed, it will be nec-
essary to enter the password. Refer to page 4-1.
NOTE: the starter key is also used to lock the cab door,
the DEF/A B ® tank cover, the engine hood, the front
D LUE
storage box, the side doors and the fuel tank cap.
(2) Engine speed throttle and work mode selector.
(3) Engine low idle speed button: the engine low idle
speed button enables to set the engine speed to low idle
at a touch without moving the engine speed throttle. If
operating at engine speed different from low idle, press
and release the engine low idle speed button to get down
the engine speed to low idle. Press and release the but-
ton again to resume the engine speed set by the engine
speed throttle.
(4) Arm angle adjustment lever: the lever enables the
control arm to be adjusted in different inclines in accor-
dance with the operator's body profile. Hold the lever and
select the desired position, and then release the lever.
3 - CONTROLS AND INSTRUMENTS
SMIL15CEX8518EA
NOTE: stop the engine when adjusting the control arm.
(5) Not active.
(6) One-touch wiper button: press and hold down the but-
ton to operate the wiper.
(7) Auxiliary port.
(8) USB port.
(9) Radio.
(10) Travel alarm switch.
(11) Overload warning switch (optional, refer to Chapter
9).
NOTE: the overload warning alarm is mainly intended for
safe operation in loads handling application. Do not acti-
vate it during digging or truck loading application.
(12) Beverage can holder.
3-22
1