Table of Contents
Advertisement
7. Clean the mating surfaces on the adapter. Check the
adapter for wear and damages.
8. Insert a new tooth as it completely mate the adapter.
9. Insert the mounting pin. Push until the locking stud
touches the aligning surface on the adapter.
10. Turn the locking stud 90° clockwise using an hexag-
onal wrench in order to lock the mounting pin in posi-
tion.
11. Make sure that the tooth is aligned with the adapter,
and that it has no backlash.
NOTE: if all teeth have to be replaced, it is recommended
to remove them starting from tooth (1) up to tooth (2). It is
also recommended to follow the same order from (1) to (2)
to install the new teeth.
6 - MAINTENANCE
6-82
4
SMIL16CEX0462AA
5
SMIL16CEX0461AA
6
SMIL16CEX0477AA
Advertisement
Table of Contents
