Case CX490D Operator's Manual page 188

Machine setup
Accurately clean the machine undercarriage and tracks to
prevent mud or debris from skidding during transport.
Get on the machine and start the engine.
Make sure to deactivate the auto idle function and the auto
shut-down function. Press the idle mode button (1) until
any idle icon on the display turns off.
Press the travel mode selector button (2) to select the low
travel speed. The "Turtle" icon appears on the display.
Select the H work mode and set the gate lock lever in
forward position.
Raise the boom so as not to interfere with the trailer bed.
Align the upper frame to the undercarriage so as the cab
is over the idler wheels.
Get the machine close to the trailer: the idler wheels
should face the trailer ramps, and the undercarriage
should be centered respect to the trailer.
Slowly climb the trailer ramps.
Slowly travel on the trailer bed to reach the resting posi-
tion.
Lower the boom to the trailer bed.
5 - TRANSPORT OPERATIONS
5-10
2
SMIL14CEX2560AB
3
SMIL19CEX2028AA
4
SMIL19CEX2027AA