Case CX490D Operator's Manual page 107

BLUETOOTH
• Can be used when a Bluetooth unit is connected.
• Press the MODE button to switch the audio source and check that BT is shown on the display.
• To use the Bluetooth function, perform pairing of the devices to be connected with a wireless connection.
Button operations when Bluetooth is selected as an audio source
Button operations
UP/DOWN
PRESET1
PRESET2
PRESET3
PRESET4
PRESET5
Volume adjustment button +
Volume adjustment button -
Bluetooth Pairing
NOTE: To use Bluetooth audio devices, the devices to be connected with a wireless connection must be registered
in advance. This registration is called pairing. If a device has never been paired, pairing must be performed.
1. When you hold down the auto preset button with BT displayed, WA will appear on the display, and this system will
start preparations for pairing.
2. On completion of the preparations for pairing, PA appears on the display and the system goes on standby for
pairing. Then, search for and pair the device, such as a cellular phone and a portable audio player, to connect
wirelessly.
3. When the pairing is completed successfully, PO appears on the display. If the pairing is not completed within
the time limit 180 s or if any abnormality occurs, PX appears on the display. If the pairing fails, retry the pairing
procedure from step 1.
Use of cellular phone connected via bluetooth
• When the paired cellular phone gets a call, CL will blink on the display and the speaker will output the ringtone.
Even if power to this system is off, its power will turn on automatically and CL will appear when it gets a call.
• You can start talking by pressing any button other than the power and the volume adjustment button when it gets
a call.
• To reject a call, press the power button. The call will be interrupted, and the band will be restored to its original state.
• While talking, you can adjust the speaker volume by using the volume adjustment button. The preset button 6
allows you to turn on and off the microphone function. With the microphone off, the audio input from here will be
stopped.
• To finish talking, press the power button. The band will be restored to its original state.
• By holding down the mode selector button, RE will appear on the display for 3 s. After redialing, DL will appear,
and the speaker will output the ringing tone.
3 - CONTROLS AND INSTRUMENTS
Short press
Long press
Short press
Long press
—
—
—
RANDOM
Track down
—
Track up
—
PLAY/PAUSE
Volume up
Volume down
3-55