Table of Contents
Advertisement
• Hours adjustment
Pressing the tuning buttons while hours section is flashing allows you to make adjustments.
Pressing the up button (7) moves the time forwards. Pressing down button (7) moves the time backwards.
• Minutes adjustment
Pressing the tuning buttons while minutes section is flashing allows you to make adjustments.
Pressing the up button (7) moves the time forwards. Pressing down button (7) moves the time backwards.
11. REDIAL
Regardless of the current band, if you hold down the MODE button, RE is displayed for 3 s and redialing is
performed. After redialing, DL flashes and ring sounds are output from the speaker. Even when the radio unit
power is off, if you hold down the MODE button, the power is automatically turned on and redialing is started.
12. External input port (AUX IN): To use this, connect it to the headphone port on your portable audio player through
a commercially-available stereo mini plug cord.
13. External input terminal (USB): connect a commercially-available USB memory.
To listen to the radio
1. Turn the starter key to ACC or ON, then press the power button to turn the radio power on.
2. With the band button, select either MW (AM) or FM .
3. Select a station with a preset buttons or with the tuning buttons.
4. Adjust the volume with the volume adjustment buttons.
5. To switch off the radio, press the power button.
Manual tuning
Pressing the "TUNE" (7) button once raises the reception frequency one step. Pressing the "TUNE " (7) button once
lowers the reception frequency one step.
Automatic station selection (Seek)
Holding down the "TUNE" (7) button increases frequency automatically. Holding down the "TUNE (7)" button de-
creases frequency automatically. When a receivable broadcasting station is found, searching stops at that frequency
and it is received.
Setting the preset buttons
1. Press the MODE button to select MW (AM) or FM and press the tuning buttons to select a broadcasting station.
2. Hold down the desired numbered preset button until the preset button number flashes three times on the display.
The preset button is now set to the selected station.
3. Repeat steps 1 and 2 to preset other broadcasting stations.
Auto preset
• By holding down the auto preset button, frequencies with good reception are detected and registered on the preset
memories 1 to 6 automatically.
NOTE: When the auto preset function is used, the registered broadcasting stations will be eliminated. To register
them on the desired buttons, use the preset function.
3 - CONTROLS AND INSTRUMENTS
3-53
Advertisement
Table of Contents
