Case CX490D Operator's Manual page 62

Confirmation of the control pattern selection
1. Get onto the cab and make sure to place the sheet that
maps the operating controls to the side corresponding
to the selected control pattern ( C or D ).
2. Start the engine and check that the operating pattern
of control levers is consistent with the position selected
on the valve and shown by the mapping sheet.
Travel controls
1. Left-hand travel control lever and pedal
2. Right-hand travel control lever and pedal
3. Footrest
4. Single travel pedal
The travel control levers and pedals are used to move the
machine.
(N): neutral
(a) + (b): machine moves forward.
(c) + (d): machine moves backward.
(b) + (c): opposite simultaneous rotation of the tracks
with consequent counterclockwise rotation of the machine
around its centre axis.
(a) + (d): opposite simultaneous rotation of the tracks with
consequent clockwise rotation of the machine around its
centre axis.
(a), (b), (c), (d): positions to move one track only. Con-
sequently the machine steers pivoting on the stationary
track.
3 - CONTROLS AND INSTRUMENTS
3-10
11
SMIL14CEX1671AA
12
SMIL16CEX0262AA
13
NH0159