Removing Transport Lock; Installing Transport Lock - Primes MicroSpotMonitor Plus HighBrilliance Original Instructions Manual

6.2

Removing transport lock

After unpacking the device, the transport lock has to be removed first. The transport lock secures the linear
carrier of the z-axis. It is located on the base plate and is fastened with three screws (see Fig. 6.1 on page
24).
Fig. 6.1: Position of the transport lock at MSM+ HB10
The transport lock of the MSM+ HB20 is longer than the one shown here.
Keep this transport lock in a safe place, as it should be reassembled before each transport of the device.
6.3

Installing transport lock

Install the transport lock before storing or transporting the device. The transport lock secures the camera
cassette to the base plate of the device and prevents misalignment of the axes due to mechanical influences.
The misalignment of the camera housing has a direct influence on the adjustment of the fiber bridge.
X Installing the transport lock
1. Disconnect the device from the LaserDiagnos-
tics software LDS and switch it off as described
in chapter 9.3 on page 47. Make sure that
the camera housing is in the zero position be-
fore switching off.
2. Install the transport lock with three M4x10
cylinder head screws. (The transport lock of the
MSM+ HB20 is longer than shown here.)
24
MSM+ HB
Transport lock
Revision 00 EN - 02/2022