Change Aperture At The Beam Entrance; Measures For The Product Disposal - Primes MicroSpotMonitor Plus HighBrilliance Original Instructions Manual

11.4.4

Change aperture at the beam entrance

Observe the warning messages above
Fig. 11.5: Changing the aperture at the beam entrance
12

Measures for the product disposal

As a B2B device, this PRIMES measuring device is subject to the European Waste Electrical and Electronic
Equipment (WEEE) Directive and the corresponding national laws. The WEEE directive obliges the operating
company to dispose of the device in an environmentally sound manner, not with household waste, but in a
separate WEEE collection.
PRIMES gives you the opportunity to return your PRIMES measuring device for free disposal within the
scope of the Waste of Electrical and Electronic Equipment (WEEE Directive). This service does not include
shipping costs. You can send PRIMES measuring devices to be disposed of within the EU to our address:
PRIMES GmbH
Max-Planck-Str. 2
64319 Pfungstadt
Germany
If you are located outside the EU, please contact your local PRIMES distributor to discuss the disposal pro-
cedure for your PRIMES measuring device.
PRIMES is a registered manufacturer in the German "Used Appliances Register" stiftung elektro-altgeräte
register (stiftung ear). Our number is: WEEE-reg.-no. DE65549202.
94
Required tools:
Allen wrench, SW 3
1
Components:
2
1 Cylinder head screw ISO 4762 M4x10
2 Aperture
3
3 O-ring 21,95 x 1,78
4 Centering ring (option)
4
1. Unscrew two cylinder head screws (1) with spring lock
washer and washer.
2. Remove the aperture (2) .
3. Check O-ring (3) for damage and replace if necessary.
Important!
The mounting holes in the aperture have a tolerance to
center the aperture. A centering ring (4) can be used as a
positioning aid.
4. Put on the new aperture with O-ring and center it.
5. Fasten aperture with two cylinder head screws (1)
MSM+ HB
Revision 00 EN - 02/2022