Table of Contents
Advertisement
1. Connect water in to PLM.
2. Connect water out at PLM to water in at MSM+ HB, using the supplied hose.
3. Connect water out at MSM+ HB to cooling.
In the case of an MSM+ HB10, the temperature sensor embedded in a T-adapter must be installed be-
tween the MSM+ output and the chiller.
The lengths of the hose has an influence on the time constants of the measuring device. Only use
the hose supplied!
16.2.2
Electrical connections
Connect USB
Connect the USB port of the PLM to the PC or network using the supplied USB-cable.
Connect temperature sensor
•
MSM+ HB10:
Install the temperature sensor, which is integrated within a T-adapter, between the MSM+ output and the
chiller
•
MSM+ HB20:
Connect the permanently mounted temperature sensor cable (black cable on the water return of the
MSM+ HB20) to the PowerLossMonitor PLM
Connect interlock
Connect the interlock of the PowerLossMonitor PLM to the Safety-Circuit-PLM-In of the MSM+ HB. For this
purpose, use the enclosed 8-pin cable which is pre-assembled on both sides.
16.2.3
Transport or storage of the PowerLossMonitor PLM
The cooling circuit of the PLM must be drained completely before transport or storage. Temperatures close
to or below freezing point can lead to damages due to the formation of ice, if the cooling circuit is not com-
pletely drained.
NOTICE
Damage of the turbine
The turbine is not designated for high rotational speed.
X Do not use compressed air to drain the cooling circuit of PLM.
Unlike the MSM+ HB, the cooling circuit of the PLM is not allowed to be drained with compressed air.
1. Remove cooling circuit hoses.
2. Drain the cooling circuit completely.
3. Seal the connectors of the cooling circuit us-
ing the enclosed plugs.
108
Cooling circuit connectors
Revision 00 EN - 02/2022
MSM+ HB
Advertisement
Table of Contents
