Primes MicroSpotMonitor Plus HighBrilliance Original Instructions Manual page 72

Adjusting size and position of the
measurement window (optional)
11. Make sure that the autom.
Measurement window option is not
enabled. Otherwise, the manual set-
ting may be overwritten when starting
a measurement.
12. Use one of the following options to
adjust the size of the measurement
window:
X Enter the length of a horizontal /
vertical side in the input field on the
left / right.
X Position the mouse pointer anywhe-
re within the measurement range
and drag while holding down the
left mouse button. Keep the mouse
button pressed until the measurement
window meets your requirements.
13. Use one of the following op-
tions to adjust the position of the
measurement window:
X Enter the x-position / y-position of the
center of the measurement window in
the input field on the left / right.
X Position the mouse pointer within the
measurement window. Then drag
while holding down the right mouse
button.
14. Click the Start button to perform the
measurement in the manually custo-
mized measurement window.
15. To stop the measurement, click on
the Stop button.
16. Switch off the laser after the
measurement is completed, unless
you want to perform further measu-
rements.
72
MSM+ HB
Revision 00 EN - 02/2022