Table of Contents
Advertisement
Option
Graphic representation
z-Position in mm
Reset measurement window
z-Increment in mm
Power P in W *
autom. Measurement window
Window size in mm
Tab. 9.3:
Options in the Device control > Settings tab of the Single planes measuring mode
58
Explanation
In a window in the upper area of the Settings tab, the measurement
plane is displayed graphically. Here you can see:
•
the entire measurable area (measurement range, thin lines)
•
the area to be recorded (measurement window, thick lines)
•
after a measurement a false-color image of the recorded area
You can make changes in the graphic representation as follows:
X To create a new measurement window, position the mouse pointer
anywhere within the measurement range. Drag while holding down
the left mouse button. Keep the mouse button pressed until the
measurement window meets your requirements.
The maximum size of the window depends, among other things, on
the magnification of the measuring objective.
X To move the measurement window to another location, position the
mouse pointer inside the measurement window. Drag while holding
down the right mouse button.
X To zoom to the center of the graphic representation, first move the
mouse pointer over the graphic representation until the plus / minus
buttons appear. Then press the buttons.
X To zoom in on the position of the mouse pointer, position the mouse
pointer anywhere within the graphic representation. Then turn the
mouse wheel.
X To set the zoom section to the size of the measurement window,
position the mouse pointer inside the measurement window. Then
double-click left.
X To set the zoom section to the size of the measurement range,
position the mouse pointer outside the measurement window. Then
double-click left.
Use one of the following options to set the desired z-position of the
plane to be measured:
X Enter a value in the input field.
X Use the slider on the left side of the graphic representation.
X Click this button to maximize the measurement window and simul-
taneously center it in the measurement range.
X If you want to measure multiple planes with fixed spacing, enter the
desired z-increment (see chapter 9.5.4, „Measure further planes",
on page 65).
To calculate the power density, the laser power used must be entered.
Otherwise, the measured amplitudes are given directly in counts.
X Enter the laser power used during measurement.
If this option is enabled, then the measurement window size will be set
automatically.
X Set the check mark to enable the option.
The maximum size of the measurement window depends, among other
things, on the magnification of the measuring objective.
If the autom. Measurement window option is disabled, the size of
the measurement window can be adjusted manually. Use one of the
following options:
X Enter the length of a horizontal / vertical side in the input field on the
left / right.
X Position the mouse pointer anywhere within the measurement
range and drag while holding down the left mouse button. Keep the
mouse button pressed until the measurement window meets your
requirements.
MSM+ HB
Revision 00 EN - 02/2022
Advertisement
Table of Contents
