Table of Contents
Advertisement
Option
Fast Mode
Parameter settings
Save current parameters
Load last parameters
Tab. 9.5:
Options in the Device control > Settings tab of the Monitor measuring mode
68
Explanation
If this option is enabled, the plane is displayed with a higher frame rate.
Note, however, that no corrective measurements are then performed.
The measurement data may therefore be affected by measurement
artefacts such as the readout noise "smear effect". In addition, no radii
are displayed in the False-color image tool.
X Set the check mark to enable the option.
All settings in the Device control menu can be individually saved for
each device. The saving location is the local installation of the LaserDia-
gnosticsSoftware LDS.
X Click this button to save all current settings of the connected de-
vice.
X Click this button to load the last saved device configuration.
MSM+ HB
Revision 00 EN - 02/2022
Advertisement
Table of Contents
