Table of Contents
Advertisement
MSM+ HB
9.5.4
Measure further planes
Directly after a plane measurement, further measurements at other z-positions can be performed. Doing so a
caustic with individual increments can be measured.
Single measurement at a specific
z-position
1.
Click on the Settings tab.
2.
In the z-Position in mm field, enter
the desired position of the next plane
to be measured.
3.
Start and stop the measurement
according to chapter 9.5.3 on page
63.
Single measurements using z-incre-
ment spacing
1.
Click on the Settings tab.
2.
Enter the spacing for the further
measurements in the z-Increment in
mm field.
3.
Start a measurement by clicking on
the Start button and wait until the
measurement is completed (see
chapter 9.5.3 on page 63).
The measured plane is one z-in-
crement away from the previously
measured plane.
4.
Click the start button again and wait
until the measurement is completed
(see chapter 9.5.3 on page 63).
The measured plane is one z-in-
crement away from the previously
measured plane.
5.
Repeat the last step as often as you
like.
Series measurement using z-increment
spacing
The combination of the Time series and
z-Increment in mm options enables
measuring a free caustic in one run.
1.
Click on the Settings tab.
2.
Enter the spacing for the planes to be
measured in the z-Increment in mm
field.
3.
In the Number of measurements
and Interval between measure-
ments in s fields, enter the number of
measurements and the interval. The
interval is the time between the end
of one measurement and the start of
the next.
Start and stop the series
measurement according to chapter
9.5.3 on page 63.
Revision 00 EN - 02/2022
65
Advertisement
Table of Contents
