Table of Contents
Advertisement
9.4.3
Open a measuring mode with adapted toolbench
In the Device control menu, a measuring mode can be selected. Here, all relevant settings for a measuring
task are clearly arranged in a menu. For example, to measure individual planes, the Single planes mode
provides all the options necessary.
The following measuring modes can be selected:
•
Single planes (see chapter 9.5, „Single planes measurement", on page 57)
•
Monitor (see chapter 9.6, „Continuous plane measurement (Monitor)", on page 66)
•
Manual caustic (see chapter 9.7, „Manual caustic measurement", on page 73)
•
Automatic caustic (see chapter 9.8, „Automatic caustic measurement", on page 79)
•
Beam pointing (see chapter 9.9, „Beam pointing", on page 84)
•
Fiber mode (see chapter 9.10, „Fiber mode measurement", on page 88)
Opening a measuring mode and the
adapted toolbench
1.
Open the Device control menu
according to chapter 9.4.1 on page
51 .
2.
After opening the Device control
menu, click the button of the desi-
red measuring mode, for example
Single planes.
A drop-down list for changing the
measuring mode appears in the up-
per area of the Device control menu.
Optional:
3.
Click on the arrow to open the drop-
down list.
4.
Click on the measuring mode to
which you want to switch.
52
MSM+ HB
Revision 00 EN - 02/2022
Advertisement
Table of Contents
