Table of Contents
Advertisement
MSM+ HB
The toolbench adapted to the selec-
ted measuring mode is automatically
opened in the main area of the user
interface.
Only if the Open measurement toolben-
ches option is disabled in the Ext-
ras > Options menu:
The Open measurement toolbench
button appears in the upper area of
the Device control menu.
This button also appears for the selected
measuring mode whenever the custo-
mized toolbench had been closed.
5.
Click this button to open the adapted
toolbench in the main area of the user
interface.
9.4.4
Configure and save measurement settings
After selecting a measuring mode, numerous measurement and device settings in the Settings and Advan-
ced tabs of the Device control menu can be configured. Which options exactly and what you need to know
about them is described in the following chapters on the different measuring tasks. However, some operating
steps in the Device control menu apply equally to all measuring modes. They are described in the following
overview.
When configuring settings in one mode, note that some options may also be offered in other modes. For ex-
ample, if a parameter is entered in the Single planes mode, it will automatically be applied to all other modes
that have that same parameter field.
When saving / loading a configuration, note that although the command is made in a specific measuring
mode, the saved / loaded data set also includes the settings of the other measuring modes.
Revision 00 EN - 02/2022
53
Advertisement
Table of Contents
