Table of Contents
Advertisement
Disconnect and switch off the device
9.3.4
When measurements are completed, the device must be disconnected from the LaserDiagnosticsSoftware
LDS and switched off.
The camera housing must be in the home position before the device is transported or stored.
If the camera body was not in the home position when the device was switched off, it will move
back to home position when it is switched on again (see chapter 9.3 on page 47).
1.
Click on the Devices tab.
2.
Right-click on the device and select
the Disconnect menu point.
The Close connection window ap-
pears.
3.
Select one of the options offered:
X Confirm by clicking the OK button.
Select this option to prepare the
device for transport or storage.
The device is disconnected from
the LaserDiagnosticsSoftware LDS.
The camera housing moves to home
position.
X Click on the Cancel button.
The device is disconnected from
the LaserDiagnosticsSoftware LDS.
The camera housing remains in the
current axis position.
4.
Switch off the device.
The status display turns off.
5.
Disconnect the electrical connections
if necessary.
50
On/Off switch
Status display
MSM+ HB
Revision 00 EN - 02/2022
Advertisement
Table of Contents
