Table of Contents
Advertisement
MSM+ HB
1
Basic safety notes
Intended use
The device has been designed exclusively for measurements in the beam of high-power lasers.
Use for any other purpose is considered as not intended and is strictly prohibited. Furthermore, intended use
requires that you observe all information, instructions, safety notes and warning messages in this operating
manual. The specifications given in chapter "14 Technical data" on page 97 apply. Any given limit values
must be complied with.
If not used as intended, the device or the system in which the device is installed can be damaged or dest-
royed. In addition, there is an increased risk to health and life. Only use the device in such a way that there is
no risk of injury.
This operating manual is an integral part of the device and must be kept in the immediate vicinity of the place
of use, accessible to personnel at all times.
Every person who is responsible for the installation, start-up or operation of the device must have read and
understood the operating manual and, in particular, the safety instructions.
If you still have questions after reading this operating manual, please contact PRIMES or your supplier for
your own safety.
Observing applicable safety regulations
Observe the safety-relevant laws, guidelines, standards and regulations in the current editions published by
the state, standardization organizations, professional associations, etc. In particular, observe the regulations
on laser safety and comply with their requirements.
Necessary safety measures
The device measures direct laser radiation, but does not emit any radiation itself. However, during the mea-
surement the laser beam is directed at the device. This produces scattered or directed reflection of the laser
beam (laser class 4). The reflected beam is usually not visible.
Protect yourself from direct and reflected laser radiation while working with the device by taking the following
measures:
•
Never leave the device unattended when taking measurements.
•
If the device is moved from its aligned position, increased scattered or directed reflection of the laser
beam occurs during measuring operation. Fix the device in such a way that it cannot be moved by unin-
tentional bumping or pulling on the cables.
•
Connect the laser control's safety interlock to the device. Check that the safety interlock will switch off
the laser properly in case of error.
•
Install safety switches or emergency safety mechanisms that allow the laser to be switched off immedia-
tely.
•
Use suitable beam guidance and beam absorber elements which do not emit any hazardous substances
when irradiated.
•
Wear safety goggles adapted to the power, power density, laser wavelength and operating mode of the
laser beam source in use.
•
Wear suitable protective clothing or protective gloves if necessary.
•
If possible, also protect yourself from direct laser radiation and scattered radiation by using separating
protective devices that block or attenuate the radiation.
Revision 00 EN - 02/2022
9
Advertisement
Table of Contents
