Measure A Caustic Manually - Primes MicroSpotMonitor Plus HighBrilliance Original Instructions Manual

9.7.3

Measure a caustic manually

DANGER
Serious eye or skin injury due to laser radiation
X Observe the warning messages in chapter 9.1 on page 44.
1. Switch on the laser.
2. Click the Start button.
 The measurement begins.
3. Optional:
If necessary, click the Stop button to
end the measurement prematurely.
During the measurement, the pro-
gress is shown in the following indica-
tors:
Measuring caustic
While the indicator is rotating, the
measurement is performed. The
measurement parameters are optimized
according to Primes quality criteria.
Measurement completed
After successful measurement, the indica-
tor lights up green.
4. Switch off the laser after the
measurement is completed, unless
you want to perform further measu-
rements.
Averaging (if enabled)
The indication shows the measured pla-
nes that are used to average a measured
value.
Applying a caustic suggestion (optio-
nal)
After the measurement is completed,
a z-range is displayed in the Caustic
suggestion fields. The limits of the
suggested z-range have a distance of
± 3 Rayleigh lengths to the determi-
ned beam waist position.
This z-range is optimized according
to Primes quality criteria.
5. If you want to apply this suggestion,
click the Use button.
The suggested limit values z1 / z2 are
transfered to the z-Axis position (z1 /
z2) in mm fields.
6. Click the Start button again to per-
form the measurement in the sugges-
ted z-range.
7. Switch off the laser after the
measurement is completed, unless
you want to perform further measu-
rements.
78
MSM+ HB
Revision 00 EN - 02/2022