Table of Contents
Advertisement
MSM+ HB
7. Remove compressed air hose from the connection for the housing flushing.
8. Remove the fastening screws (see Fig. 11.2 on page 91).
9. Remove measuring objective
10. Dry and clean the measuring objective.
Fig. 11.1:
Openings of the measuring objective (foto shows MSM+ HB10)
S3
Fig. 11.2:
Screws to fasten the objective
Revision 00 EN - 02/2022
Measuring Output
S1, S2
Beam Entrance
Laser Output
The objective is fastened at the device by
means of three screws. The two screws
S1 and S2 (M3x16, AF 2.5 mm) are re-
quired for the fastening of the objective on
the device surface.
Another screw S3 (M5 x 15, AF 4 mm)
fastens the upright of the device laterally.
91
Advertisement
Table of Contents
