Setting Up The Osa For Remote Operation - Agilent Technologies 8614 B Series User Manual

Remote Front Panel Operation
Remote Front Panel

Setting Up the OSA for Remote Operation

1 From the OSA's front panel, press System > More System Functions > GPIB & Network Setup >
Configure Network.
2 When the Network Configuration screen is displayed, press Continue.
The OSA will now restart the operating system and load the Network Configure utility.
3 From the Network Configure Utility window, press OK.
4 When the Network Configure window opens, press Configure.
During the configuration process, you will be prompted to enter each of the networking parame-
ters as described below. If networking is currently configured, you have the option of accepting
the current configuration or updating the networking parameters.
Tip: This is where you can verify the current network settings.
Pressing Unconfig will disable the current network configuration, if any.
5 The HP-UX Set Systems Parameters panel is displayed. You will use this panel to supply the
information needed to configure the OSA on the network. Press Yes to continue.
6 The Required Information window will open. You need to obtain the name of your system
(hostname) and your Internet Protocol (IP) address information from your local network
administrator before proceeding. Press Yes, Continue if you have the necessary information.
7 Enter the Hostname for your OSA, then press OK.
8 Press Yes to confirm the hostname.
9 You will now be prompted to enter the time zone settings for the OSA. It is important that the OSA
time and time zone are consistent with the network where it resides.
10 Select the Time Zone region in which the OSA resides, then press OK.
11 Select the time and date for the OSA time zone and press OK. Press Yes to confirm the correct time
zone or press No if the information is not correct.
12 A window is displayed showing the current time and date of the time zone selected, press Yes if
correct, or No to make corrections.
13 In the System Internet Address panel, enter the Internet Address then press OK. Press Yes if the
address is correct.
14 When prompted to enter additional network parameters, press Yes.
15 Enter the Subnetwork Mask and Gateway IP Address then press OK. If the parameters are correct,
press Yes.
4-4