Table of Contents
Advertisement
Getting Started
Making a Measurement
Making a Measurement
This procedure will introduce you to the Agilent 8614x series optical spectrum analyzer front
panel controls. By following this procedure you will do the following:
• Perform an auto alignment
• Perform a peak search
• Use a delta marker
• Print the display
Refer to "The Menu Bar" on page 1-15
Instrument setup
A source signal must be present at the input of the optical spectrum analyzer. In this procedure a
Fabry-Perot laser is used as the source. You can use another source or the optional 1310/1550
nm eeled. If another source is being used, the display will differ from those shown.
To set the OSA to a known state
• Press the front-panel Preset key to set the instrument to a known state. For a complete descrip-
tion of preset conditions, see
1-12
and
"The Softkey Panels" on page
page
3-59.
1-16.
Advertisement
Table of Contents
