Agilent Technologies 8614 B Series User Manual page 212

Status Listings
OSA Warnings
Table 5-6. OSA Warnings (10 of 12)
Error Number Error Description [description/explanation/examples]
6737 desc = "Invalid math constant"
help = "During evaluation of a math expression an invalid constant was
encountered. The constant has undefined or default settings for it's X and/or Y
values."
6738 desc = "Out of memory"
help = "A trace or math operation was requested. There is insufficient memory
available to perform the operation. Try reducing trace length or cycle power."
6739 desc = "Too many peaks or pits"
help = "A marker search operation was requested. There are too many valid pits or
peaks in the current trace. Reduce the number of valid pits or peaks by increasing
the peak or pit excursion setting."
6741 desc = "Constant with multiple Y values"
help = "During evaluation of a math expression a constant was encountered which
contains more than one Y value. Constants are only permitted to have one Y value."
6742 desc = "Requested amplitude not found"
help = "A math expression to search for a specific amplitude in a trace did not
succeed. There are no trace points with the desired amplitude."
6744 desc = "Excursion should be in dB"
help = "The units for the excursion are not in dB."
6745 desc = "Log of a negative number is not allowed."
help = "During evaluation of a math expression the logarithm of a negative number
was encountered."
6746 desc = "Math expression contains a circular reference."
help = "A new math expression was entered. The expression was rejected because
it would create a circular reference. For example if trace math for trace C is set to
(A-B) then setting trace math for trace B to (C+D) would create a circular
reference."
6747 desc = "Next peak not found"
help = "A next-peak search was requested. There are no more peaks on the
current marker's trace in the requested direction. To find additional peaks reduce
the marker peak excursion setting or adjust sensitivity."
6748 desc = "Next pit not found"
help = "A next-pit search was requested. There are no more pits on the current
marker's trace in the requested direction. To find additional pits reduce the marker
pit excursion setting or adjust sensitivity."
5-26